Installation Guide

We Always Adhere To Your Safety First
×   Notice :  Before You Begin The Installation Work
These Are General Installation Instructions Only. The Information On These Pages Is To Assist & Guide You The Appropriate Rubber Tile Installation For Your Project Special Conditions May Result In Different Recommendations.


Substrate

Suitable substrates include but are not limited to permanently dried concrete and wood.
To eliminate the telegraphing effect of defects in the substrate through the flooring, the substrate must smooth.
Remove all dust, dirt, grease, and foreign materials from the substrate.
Moisture in the substrate negatively affects an adhesive product and should be eliminated prior to installation.

CAUTION- cinder fill, vermiculite, pumice and other aggregates which are hygroscopic in nature cause the concrete to be very slow drying. This type of concrete will easily absorb excessive moisture from the atmosphere and other sources. Any concrete curing compound must be completely removed.


Contact Us    

Responsive

Inspect flooring prior to installation for manufacturing defects, correct colors, and size. See warranty statement for details.
Be sure the sub-floor is smooth, clean, dry and free of dust or contamination. If rubber tiles are to be installed, cut to fit before spreading adhesive.
For the best result, rubber tile, room and adhesive should be 70°F (21°C) 48 hours prior to, during and after installation.
Apply adhesive with a notched spreader having notches 1/16" deep, spread 1/16" on centers. Apply only to an area of such size that tile can be set while adhesive is still wet. Avoid letting the adhesive skin over.
Set tile in place immediately. Lift a newly set spot occasionally to be sure adhesive is transferring to back. Press tile in firmly with hands.
Immediately after installation, roll the flooring with 100 to 150 pound sectional rollers. For tile installations begin at one side and proceed slowly to the other. All installations should be rolled in both directions. IT may be necessary to weight the seam until a suitable bond has been established.
Wet adhesive smears should be removed immediately with a damp cloth. Dry adhesive can be cleaned with mineral spirits. Be careful: mineral spirits are harmful to floor coverings and will ruin the adhesive bond if it gets under the floor covering.
Do not place playground equipment, furniture. Allow traffic, or institute general cleaning procedure until 48 hours after installation.

Approximate coverage 100 square feet per gallon.


Contact Us    

If you have any enquiries on our company or the product & services, Please contact us!

Whatapps : +6012 3366919 (International)
+6011 12387331 (Malaysia)

Contact Us

Address:
Lot 5197, Kawasan Perindustrian Balakong Jaya 2, Jalan Balakong Batu 12, 43300 Seri Kembangan, Selangor, Malaysia
Phone: + 603 - 8962 6628
Email: sales@supersafe.com.my
Fax: +603 - 8962 6629